Share ChristopherK's profile
 
 
 
ChristopherK
 
 
 
ChristopherK's stats
 
Reviews
  • Review count
    0
  • Helpfulness votes
    0
  • First review
    None
  • Last review
    None
  • Featured reviews
    0
  • Average rating
    0
 
Reviews comments
  • Review comment count
    0
  • Helpfulness votes
    0
  • First review comment
    None
  • Last review comment
    None
  • Featured review comments
    0
 
Questions
  • Question count
    0
  • Helpfulness votes
    0
  • First question
    None
  • Last question
    None
  • Featured questions
    0
 
  • Answer count
    415
  • Helpfulness votes
    31
  • First answer
    June 5, 2013
  • Last answer
    September 9, 2014
  • Featured answers
    0
  • Best answers
    0
 
 
ChristopherK's Reviews
 
ChristopherK has not submitted any reviews.
 
ChristopherK's Review Comments
 
ChristopherK has not submitted comments on any reviews.
 
ChristopherK's Questions
 
ChristopherK has not submitted any questions.
 
ChristopherK's Answers
1 2 3 4 5 ... 42 next>>
 
Wall Air Conditioner w/Heat, BtuH Cooling 11,200/11,500, BtuH Heating 9,200/11,200, Voltage 208/230, Operation Mode Cool/Heat, EER 9.4/9.4, Amps 5.6/6.0, Watts 1220/1190, Dehumidification Rate 3.8 pts./hr., High CFM 290, Control Type Digital, Refrigerant Type R-410A, Power Cord Length 4 ft., NEMA Plug Configuration 6-20P, Fan Speeds Cooling 3, Fan Speeds Heating 3, Fan-Only Speeds 3, Air Flow Direction 6 Way, Width 24-5/8 In., Depth 18 In., Height 14-3/8 In., Max. Wall Thickness 16-3/4 In.
 

How many decibles is this when operating?

I'd like to make sure I can sleep with this on.
Grainger has contacted the product supplier and has been advised by them of the following. This product has no published sound ratings. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Hydronic Unit Heater, Heater Type Water/Steam, Fan Guard Type Non OSHA, Output @ 2 PSI Steam 108,000 BtuH, Output @ 200 F Water 78,400 BtuH, Air Flow 1800 cfm, Motor HP 1/12, 2.2 Amps, Inlet/Outlet NPT 1-1/2 In., Height 24 In., Width 19-1/2 In., Depth 14 In., Air Flow Direction Horizontal, Coil Type Header, Voltage 115, 60 Hz, 1 Phase, Max. Operating PSI 75, Max. Operating Temp. 320 Degrees F, Motor Enclosure Totally Enclosed, Mounting Height 11 ft., Standards ETL Certified
 

Can I purcase a new coil for 5pv15a?

Grainger has contacted the product supplier and has been advised by them of the following. The replacement coil for this unit is our parts item 6178787. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Paint Collector Filter Pad, Media Synthetic Polyester, Nominal Height 20 In., Nominal Width 20 In., Nominal Depth 1 In., Filter Efficiency 98 Percent, For Use With Spray Booth Over Spray Collection. Only shipped in quantities of 30.
 

What is the filter class for the 2EKK1 Paint Collector Filter Pad, Polyester?

UL lists filter by their Air Filter Flammability Performance. Class 1 or Class 2. I would like to know if the above mentioned filter meets either of these filter performance classes.
Grainger has contacted the product supplier and has been advised by them of the following. This filter is UL class 2. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Commercial Air Cleaner, 2 Stage Hepa, Ceiling Mount, Number of Speeds 3, Air Flow 66/76/107 CFM, Filter Efficiency 99.7 %, Filter Rating Up To 0.3 Micron Microns, Sound Level dBA 60, Voltage 120, 60 Hz, 1 Phase, 150 Watts, Height 15 3/4 In, Width 24 In, Length 24 In, Powder Coat Finish, White, Comes With Hepa And Carbon Filter, Mounting Hardware And Remote Control, Agency Compliance UL
 

How many cubic feet room would Item # 2HNP4 be rated for?

Grainger has contacted the product supplier and has been advised by them of the following. These are not rated for a certain amount of cubic feet the space they will treat is dependent on the environment that it is installed in. Please give us a call so we can help you with the selection of this item. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Mixed Flow Duct Fan, Housing Material Thermoplastic, Fits Duct Dia. 6 In., Voltage 120, Max. Amps 0.54, Max. Wattage 65, Number of Speeds 2, Housing Dia. 8-11/16 In., Length 10-13/16 In., CFM @ 0.000-In. SP 333/239, CFM @ 0.125-In. SP 315/209, CFM @ 0.250-In. SP 286/181, Max. Inlet Temp. 140 Degrees F, Inlet and Outlet Dia. 6 In., 60 Hz, 1 Phase, Motor RPM 2700/2000, Motor Enclosure Totally Enclosed, Width 19-1/16 In., Height 8-11/16 In., Flange Width 1-1/12 In., Speed Control Yes
 

Is this ok for very high humidity (steam) in the air it is blowing?

I need a fan that will exhaust the steam coming out of a pump that is draining into a funnel drain in a crawl space. There will likely be a lot of condensate in the line that will drip back down into the drain, so I need a fan that can handle the condensate and what drips back down through.
Grainger has contacted the product supplier and has been advised by them of the following. These can be used to ventilate areas with steam such as a bathroom; they do not recommend it for extreme or high temperature steam or to have actual water drain through the fan. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Axial Flow Fan Blade, Diameter 9 Inches, Air Flow 500 CFM, Blade Type Hub, Width 1 3/8 Inches, Dimension B 1/2 Inch, For Use with 1550 RPM Standard Case Motor, Aluminum Cooling Fan CW
 

Does this have a set screw?

the picture shows what seems to be a fully bored hole, but most motors have a flattened spot on the shaft to keep the blade from slipping
Grainger has contacted the product supplier and has been advised by them of the following. This item does have a set screw on the hub. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Self Regulating Heating Cable, Mounting Location Wet or Dry, Cable Length 12 ft., Max. Circuit Length 250 ft., Voltage 120, 72 Watts On Metal, 96 Watts On Plastic, Plug Type NEMA 5-15, Features Easy to Install, For Use With Short Pipes, Water Pipe System, Plastic or Metal Pipe Up to 2 1/2 In. Dia., Standards UL Listed and CSA Certified
 

Can this Heat Trace be used on PEX Piping?

Grainger has contacted the product supplier and has been advised by them of the following. This item is safe for use on Pex piping. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Humidifier, Console, 0.8 Amps AC, 80 Watts, Height 18-1/2 In., Width 21-1/2 In., Depth 19 In., Max. Water Usage 12 gal./24 hr., 3.5 gal. Water Reservoir, Number of Speeds 9, Replacement Wick Mfr. No. HDC311, Cord Length 5 ft., NEMA Plug Configuration SPT-2, Color Gray/Silver/Black, Requires Three (3) High-Perfomance Essick Air Mfr. No. HDC311 Wicks, Includes Three (3) High-Perfomance Essick Air Mfr. No. HDC311 Wicks
 

I need a humidifier that will go to 85-90% humidity. I would also like a minimum of 3 gallons capacity. Do you have this?

Grainger has contacted the product supplier and has been advised by them of the following. There are many factors that would go into making sure a unit could produce the humidity needed. If you could give us a call we would be happy to help you further with this. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
OEM Blower, Rectangular, With Flange, Wheel Dia. 6-1/4 In., CFM @ 0.000-In. SP 495, Voltage 115, 50/60 Hz, 1 Phase, Full Load Amps 3.25/3.50, RPM 1570, Max. Inlet Temp. 104 Degrees F, Overall Height 12 In., Overall Width 9-1/2 In., Overall Depth 10-5/16 In.
 

What is the direction of rotation.

Grainger has contacted the product supplier and has been advised by them of the following. This unit intakes air through the round opening and discharges the air through the square opening. If you have more questions please give us a call at Grainger. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK
 
Temperature Transducer, Temp. Range 40 Degrees to 240 Degrees F, Power Required 9 to 32 VDC, Response Time (Sec.) 0.25, Output 20 A @ 12VDC, Temp. Accuracy +/-0.50 Percent, Probe Length (In.) 0.75, SAE #8 Electrical Connections
 

4UJG8 part

I need the sensor to this part. It would be the brass part in the picture.
Grainger has contacted the product supplier and has been advised by them of the following. The sensor for this item is not available separately. Thank you for using Grainger Ask and Answer.
1 month, 2 weeks ago
by
ChristopherK