how to replace brushes and their location tool. just stopped
was cutting soft wood to make a lid for something and it just stopped was thinking it just over heated, so I waited a couple hrs and still no good. tried removing shell and check out the brushes once removed the shell one brush fell out and could not see where it went. tried looking for 2nd brush not sure it even has one,, but no good
Please call Dremel customer service at 1-800-437-3635 for further assistance.
Is this the accessory for attaching the sanding disk? It has a screw threaded in the one end?
Yes, this mandrel is needed to attach the sanding discs to the tool. You’ll need to remove the screw on the tip of the mandrel, insert the screw through the center of the sanding disc and then thread the screw back onto the mandrel.
Engraver Electric Engraver, 7200 Strokes Per Minute, 0.2 Amps@120VAC,Tool Length 7 Inches, Tool Weight 0.85 Of A Pound, 5-Position Calibrated Stroke Adjustment Dial Regulates Engraving Depth, Pencil Style Soft Grip, Includes 4 Carbide Engraving Tips, Bit Case And Template For Letters and Numbers.